I have two LED devices. Which profile goes on the second one?

Load an RPM telemetry profile onto every LED device you want lit, taking the file whose middle segment matches that device. Each device keeps its own settings, so they cannot get in each other's way, and the plugin handles up to 16 of them.

This is a change, and it is why the Co-Pilot LED profile has been retired. The number of side LEDs used to be one value shared by the whole rig, so two differently shaped devices read the same number and one of them always drew in the wrong place.

Pick the device at the top of LED Devices > RPM Telemetry and everything below it belongs to that device alone:

• Its own Telemetry Function, so a wheel can show revs while a DDU shows brake pressure or the fuel gauge
• Its own effect positions for flags, spotter, brake, low fuel, ERS and the rest
• Its own rev bar style, colours, start threshold and redline behaviour
• Its own brightness, and its own idle animation
• Its own side LED count, worked out from the strip and the profile you installed

A few things stay rig wide on purpose, and the plugin marks them on screen. Specific RPMs is one switch for the whole rig, as are Last Gear Redline, the idle animation duration and everything on the Universal Settings page.

Because each device can do a different job, it is worth giving it one. Leave the rev lights on the wheel or DDU you actually look at, and set the other to brake pressure, brake and throttle input, or the fuel gauge.

If an effect lands in the wrong place on one device only, check the picker at the top of the page. Positions belong to the selected device, so it is easy to set them on the wrong one.