The Brake tab on the Telemetry, Co-Pilot and Eyebrows pages controls the brake pressure display.

Brake Pressure Type sets how the pressure is drawn:

• Telemetry LEDs (the default), which uses the side LEDs
• Left to Right
• Right to Left
• Meet in the Middle
• In to Out

Brake LED Position chooses where the effect appears, and Use Custom Position with a Start position lets you place it precisely if the default does not suit your device.

Blink Percentage Stage 1 and Blink Percentage Stage 2 set the percentage of brake force at which each stage of the blink starts. Two stages let you mark the point where you are braking hard and the point where you are close to locking, so you can feel out threshold braking visually.

On eyebrows this is described as a brake gauge with two customisable blinking stages. The blink percentages are shared with the Telemetry tab rather than being separate per device, and the plugin says so on the control.

If your device has no side LEDs configured, the brake pressure options that depend on them will say so.